Reply to thread

Message: <blockquote data-quote="lalhtt" data-source="post: 20374998" data-attributes="member: 417918">ඔටෝ ගියර්නවතා තැබීමේදී P=PARK  - the gear selector should be in this position when the car is parked  as it typically locks the transmission so that the car cannot move. In  conjunction with this, the parking brake (hand brake) may also be  applied. On most cars, the engine cannot be started unless the lever is  in this (or 'N') position. පසුපසට ගැනීමට R=REVERSE - selecting this position allows the vehicle to be driven in the reverse (backwards) direction. එන්ජිම පමනක් ස්ටාට් කර තැබීමට - තල්ලු කිරීමට N=NEUTRAL - in this position, the engine is disconnected from the drive  train (gears) and the vehicle will not be propelled in either direction  when the gas (accelerator) pedal is pressed. The wheels are not locked  and the vehicle will be able to roll downhill if the brake pedal is not  pressed. සාමාන්‍ය සමතල පාරක ධාවනයේ දී - මෙහිදී වේගය අනුව ස්වයං ක්‍රීයව අදාල ගියර් වලට මාරු වේ D=DRIVE - this is the position that is typically used when the vehicle  is being driven. As the vehicle increases (or decreases) in speed, the  automatic gear box will select the correct gear for both speed and road  conditions. එන්ජිමේ වැඩි බලයක් යොදවා හෙමින් ධාවනයට - සාමාන්‍ය කන්දක් නැග්මට හෝ බැස්මට 2=GEAR 2 - typically, automatic gear boxes have 3 of 4 forward gears, so  some vehicles may have both 2 and 3 marked on the hear selector. By  using this position, the driver 'locks' the transmission in a lower gear  so that the engine will run with increased revolutions. This is useful  when rapid acceleration is desired. It should be noted that maintaining  high revolutions in lower gears will increase the fuel consumption of  the vehicle and also the stresses on the vehicle and passengers. It  should therefore be used for short periods only. ඉතා කෙටි දුරක් එන්ජිමේ වැඩි බලයක් යොදවා හෙමින් ධාවනයට L=LOW - (may be indicated by '1') this is the lowest gear (or 1st gear)  available. This position is useful when the vehicle needs to negotiate  difficult terrain (such as a steep incline with a poor surface). For  downward slopes, the LOW gear provides additional braking through the  engine. OD=OVERDRIVE - for vehicles fitted with this option, an extra gear is  provided that has a lower ratio than the normal top gear. The power  output delivered by this gear is low in comparison to the normal gears  and is used for high speed cruising (on interstates / motorways etc).  Engine revolutions are reduced, as are noise levels. Fuel consumption is  improved.</blockquote>

Verification: Hathara warak wissa keeyada? (Hathara wadi karanna 20)

Top Bottom