Reply to thread

Message: <blockquote data-quote="sanjaya22" data-source="post: 21749323" data-attributes="member: 440978">When the switches of distribution layer are executed show spanning tree command, both switches show as a root. i think that its the problem. Further, for overcome this issue i have given spanning tree VLAN priority for each VLANS. But it was not successfully. And also, RPVST+ was also configured by me. But it was also not successfully. So i think that it i have done it wrongly. Two Root bridges should not reside in the same segment. It will analyze highest Interface IP address , Bridge ID etc to determine the root bridge.Change the MAC address of a One switch and make only one of them root bridge.</blockquote>

Top Bottom