CISCO_ROUTER_HELP

[kavindagk]

machnla mata wadak dunna CISCO ROUTER 2k connect karanne RJ45 cable use karala ithn mama e deka wena wenama config kara..but machnla mama eka ROUTER ekak 0/0 port eka anith eke 0/0 ta connect kala RJ45 ekakain eth ping kala ping wenne na ne

mama netwrok gana wadiya danne na puluwan help ekak denne....

godak ayea kiyanwa ROUTER 2k RJ45 walin connect karanne ba kiyala...

 

[dinchad]

cross cable එකක් ගහල බලපන් .router 2 k connect කරන්න මොකක්ද උබට තියන උවමනාව ..අනික මචන් එකම IP වැඩ කරන්නෙ නෑ

 

[ENEMY]

1) router to router connect karanna nam crossover cable ekak use karanna one
2) routers deke ethernet / fastetherent 0 interfaces dekama ekama network eke tiyenna one eg : 192.168.1.1 and 192.168.1.2 of subnet 255.255.255.252 means /30 . habay meke hatiyata dewani interface eke ip eka 192.168.1.2 walin ehata gioth ping wenne naha. (ip subnet zero deela tiyenna one)

3) uba configure karana nisa physically connected da kiala balanna one na.eth balapan line protocol down da kiala.administratively down kiala pennuwoth e kianne interface eka manually down karala . global mode eke interface ekata gihin "no shut down" deepan.

4) thawa deyak , uba use karanne menna me wage setup ekak nam ubata ping karanna puluwan router to router back to back setup ekata witharay.anith swtiches walata ping karanna ba mokada uba ip routing enable karala nathi nisa.ekath poddak meter karaganin.meke widiata switch eke idan router ekata ping karoth wada karanne na.ewa tiyenne wenas subnet wala.

 

[bohokal]

http://www.amazon.com/Cisco-Router-Crossover-DB60-Cable/dp/B001OC1AV6
නිකන් connect කරන්න බෑ ,dce dte serial cable තියෙන්න ඕනේ

 

[ENEMY]

http://www.amazon.com/Cisco-Router-Crossover-DB60-Cable/dp/B001OC1AV6
නිකන් connect කරන්න බෑ ,dce dte serial cable තියෙන්න ඕනේ

e machan serial connection ekak hadaddi (wan link) .etakota DCE pattata clock rate set karanna one , "show controller serial 0" deela balanna one koi pattada DCE kiala

 

[kavindagk]

cross cable එකක් ගහල බලපන් .router 2 k connect කරන්න මොකක්ද උබට තියන උවමනාව ..අනික මචන් එකම IP වැඩ කරන්නෙ නෑ

hari machan....mama CROSS CABLE gahuwa dan wada
thanks you very much

 

[kavindagk]

1) router to router connect karanna nam crossover cable ekak use karanna one
2) routers deke ethernet / fastetherent 0 interfaces dekama ekama network eke tiyenna one eg : 192.168.1.1 and 192.168.1.2 of subnet 255.255.255.252 means /30 . habay meke hatiyata dewani interface eke ip eka 192.168.1.2 walin ehata gioth ping wenne naha. (ip subnet zero deela tiyenna one)

3) uba configure karana nisa physically connected da kiala balanna one na.eth balapan line protocol down da kiala.administratively down kiala pennuwoth e kianne interface eka manually down karala . global mode eke interface ekata gihin "no shut down" deepan.

4) thawa deyak , uba use karanne menna me wage setup ekak nam ubata ping karanna puluwan router to router back to back setup ekata witharay.anith swtiches walata ping karanna ba mokada uba ip routing enable karala nathi nisa.ekath poddak meter karaganin.meke widiata switch eke idan router ekata ping karoth wada karanne na.ewa tiyenne wenas subnet wala.

thanks machan....cross cable eka gahuwama hari giya
umba dala thiyana godak ewa mata meter na eth mama hithuwa tikak e gana igena gannne mage first time me network gana balana

 

[ENEMY]

thanks machan....cross cable eka gahuwama hari giya
umba dala thiyana godak ewa mata meter na eth mama hithuwa tikak e gana igena gannne mage first time me network gana balana

ela machan good luck