CNC help

[kk97]

CNC gana danna kenek innawanam kiyanna. help eakak oone.

 

[Ashan052]

 

[1sam]

CNC gana danna kenek innawanam kiyanna. help eakak oone.

What would you like to know??

 

[kk97]

cnc kit ekak ebay eken genawa, okkoma hariyara configure kara manual eke thibba widiyata , stepper motor eka nema 23. motor eka vibrate wenawa witharayi. karakenne naa.

 

[Ashan052]

cnc kit ekak ebay eken genawa, okkoma hariyara configure kara manual eke thibba widiyata , stepper motor eka nema 23. motor eka vibrate wenawa witharayi. karakenne naa.

current eka aethida stepper eka run wenna
wire tika gehuwada hariyata loose connection nethi wenna

 

[kk97]

ow okkoma kra hariyata. can u help m at a cost?

 

[1sam]

cnc kit ekak ebay eken genawa, okkoma hariyara configure kara manual eke thibba widiyata , stepper motor eka nema 23. motor eka vibrate wenawa witharayi. karakenne naa.

Sorry, I only know about CNC programming and setting.

 

[AlanBRO]

මොනාද දැනගන්න ඕන..?

 

[kk97]

anyone can help?

 

[kk97]

මොනාද දැනගන්න ඕන..?

cnc kit ekak ebay eken genawa, okkoma hariyara configure kara manual eke thibba widiyata , stepper motor eka nema 23. motor eka vibrate wenawa witharayi. karakenne naa.

 

[AlanBRO]

cnc kit ekak ebay eken genawa, okkoma hariyara configure kara manual eke thibba widiyata , stepper motor eka nema 23. motor eka vibrate wenawa witharayi. karakenne naa.

මෝටර් වයර් හරිය⁣ට බලල සම්බන්ධ කරන්න

 

[kk97]

danna kenek innawada awilla balanna ?

location-> thalawathugoda

i will pay for the task.

 

[Ashan052]

danna kenek innawada awilla balanna ?

location-> thalawathugoda

i will pay for the task.

enta widiyak ne puthi stepper wire maru wela wage penne nm

 

[peterproud]

probably a connection problem. check twice

 

[ek_rosh]

cnc kit ekak ebay eken genawa, okkoma hariyara configure kara manual eke thibba widiyata , stepper motor eka nema 23. motor eka vibrate wenawa witharayi. karakenne naa.

Ebay, link eka danna.. Manual ekat danna...

Driver eka mokakda?
Breakout board eka mokakda?
Mach3/4 hariyata configure karada, parallel port?

 

[inspiron]

enta widiyak ne puthi stepper wire maru wela wage penne nm

Luku seen nathuwa udaaw karannakoo

 

[imhotep]

You can check the stepper motor itself if you got proper external power supplies. However you can do a simple test with a 3v LED.
Connect the LED to the two left connectors and turn the stepper by hand. The LED should light up. Then do the same for the two right connectors- LED should light up.

 

[kk97]

awilla balanna kenek innawada ?

do me a favor boys