Motherboard dead ?

[eyepea]

Removed all cards (including ram) and all cables from motherboard except the following:

cpu and cpu fan, fixed.
cpu fan cable connected to mother board.
psu 24pin cable connected to mother board.
psu 4 pin 12v cable connected to mother board.
power on/off switch in case connected to mother board.

on switching on psu, motherboard light comes on.
on pressing on/off switch, cpu fan starts.

Nothing else happens.
No beep codes.

Tried with monitor connected and also ram in (in case just on-board beeper faulty, and booting continues to display error).

I assume if it is only a beeper issue, normal booting should continue?
When ram out, there should be a beep error right?

Nothing.

Tried same psu on a different motherboard. psu is ok.
(But can't swap cpu ram to test as they are different)

Anything else I could try ?
(btw the board is a intel DG101ggc)

thanks

 

[eyepea]

Tried same psu on a different motherboard. psu is ok.

Btw, just so that others won't get shocked, I think this would be a bad idea to do normally. If the psu were bad, perhaps it could have damaged the other motherboard. The motherboard I tested on has some other problems, so it didn't matter in this case .

Any ideas for my initial issue please?
(other than try this cpu on another board, or try a compatible cpu on this board)

thanks

 

[baamitha]

මචෝ සිමොස්‌ බැටරිය ගලවා දාන්න ...

 

[Simsons]

Machan mageth oya prashne enawa. Ram eka poddak galoola gahuwama wada karanawa. Samahara welawata pain paarak dunnamath wada karnawa Habai hitapu gaman dawasak withara balan inna oni :\ Eka uuta hithunama wada karanne mata oni welawata newe

 

[eyepea]

මචෝ සිමොස්‌ බැටරිය ගලවා දාන්න ...

thanks. Will reset and see.

Machan mageth oya prashne enawa. Ram eka poddak galoola gahuwama wada karanawa.

thanks. yeah, contact problems are a bother at times.
But when ram is out, I expect a beep error code (provided on board beeper is working)

Btw, what is the best way to clean RAM contact pins if necessary?
The dimm itself, I heard can be cleaned with a rubber eraser carefully.
How about the dimm socket in the mother board? Is there any way to clean other than air blowing or vacuum? Is spraying contact cleaner recommended ?

 

[GayanSV]

Mulinma board ekata ena power off karala inna

board eke dust ekatiyanawanam hondata clean karanna.

CMOS battry eka galawala CMOS clear karanna (battery socket eke terminal niyanakin or loha keelakin shotcircuit karala or jumpers walin )

eeta passe battery eka netuwa power on karala balanna response ekak tiyanawada kiyala

tibunoth battery eka hai karala RAM ehema connect karala on karala balanna. response ekak tiyanawada kiyala

tibboth HDD and other devices connect karala balanna

 

[eyepea]

Thanks very much! Will try
(Was held up with some office work and now only have some free time to follow it up )

 

[Dulaa]

Power pitin motherboard eka allanna yanna epa... paths wala atha wedunama short wenawa... mage MB ekak burnt una ehema...

 

[jacksena]

Well you can also choose Technical Support options which is only the way here you can getting all type of computer solution such as software issue, motherboard issue, hard disk issue etc so take some tips for better computer solution.

Technical Support