good news for those who are preparing for cisco certified network associate（ccna)640-802, passcert has got the latest Q&A for the test.
here are some real questions about the test you may see to familiar with the test :
1. Refer to the exhibit. What could be possible causes for the "Serial0/0 is down" interface status?
(Choose two.)
A. A Layer 1 problem exists.
B. The bandwidth is set too low.
C. A protocol mismatch exists.
D. An incorrect cable is being used.
E. There is an incorrect IP address on the Serial 0/0 interface.
Answer: AD
2. Before installing a new, upgraded version of the IOS, what should be checked on the router, and which
command should be used to gather this information? (Choose two.)
A. the amount of available ROM
B. the amount of available flash and RAM memory
C. the version of the bootstrap software present on the router
D. show version
E. show processes
F. show running-config
Answer: BD
3. A network administrator is explaining VTP configuration to a new technician. What should the network
administrator tell the new technician about VTP configuration? (Choose three.)
A. A switch in the VTP client mode cannot update its local VLAN database.
B. A trunk link must be configured between the switches to forward VTP updates.
C. A switch in the VTP server mode can update a switch in the VTP transparent mode.
D. A switch in the VTP transparent mode will forward updates that it receives to other switches.
E. A switch in the VTP server mode only updates switches in the VTP client mode that have a higher VTP
revision number.
F. A switch in the VTP server mode will update switches in the VTP client mode regardless of the
configured VTP domain membership.
Answer: ABD
4. Which two locations can be configured as a source for the IOS image in the boot system command?
(Choose two.)
A. RAM
B. NVRAM
C. flash memory
D. HTTP server
E. TFTP server
F. Telnet server
Answer: CE
more informationand free demos about 640-802 you can visit passcert
here are some real questions about the test you may see to familiar with the test :
1. Refer to the exhibit. What could be possible causes for the "Serial0/0 is down" interface status?
(Choose two.)
A. A Layer 1 problem exists.
B. The bandwidth is set too low.
C. A protocol mismatch exists.
D. An incorrect cable is being used.
E. There is an incorrect IP address on the Serial 0/0 interface.
Answer: AD
2. Before installing a new, upgraded version of the IOS, what should be checked on the router, and which
command should be used to gather this information? (Choose two.)
A. the amount of available ROM
B. the amount of available flash and RAM memory
C. the version of the bootstrap software present on the router
D. show version
E. show processes
F. show running-config
Answer: BD
3. A network administrator is explaining VTP configuration to a new technician. What should the network
administrator tell the new technician about VTP configuration? (Choose three.)
A. A switch in the VTP client mode cannot update its local VLAN database.
B. A trunk link must be configured between the switches to forward VTP updates.
C. A switch in the VTP server mode can update a switch in the VTP transparent mode.
D. A switch in the VTP transparent mode will forward updates that it receives to other switches.
E. A switch in the VTP server mode only updates switches in the VTP client mode that have a higher VTP
revision number.
F. A switch in the VTP server mode will update switches in the VTP client mode regardless of the
configured VTP domain membership.
Answer: ABD
4. Which two locations can be configured as a source for the IOS image in the boot system command?
(Choose two.)
A. RAM
B. NVRAM
C. flash memory
D. HTTP server
E. TFTP server
F. Telnet server
Answer: CE
more informationand free demos about 640-802 you can visit passcert
