මේක මම උඹට දෙන්නේ දැනගැනීම සඳහා පමණයි ... මේ ක්රමවේදය ක්රියාත්මක කිරීමේ කැමැත්ත හෝ අකමැත්ත 100% වගකීම උඹ සතුයි.. මම මේක කරලා නැති නිසා මට මේ ගැන හරියටම වගකීමක් ගන්න බැහැ .. මේ තමයි scan tool එකක් නැතුව Toyota ABS reset කරන විදිහ..
First, connect terminal 4 and 13 of the OBD-II socket (under the dash in front of your left knee) with a jumper wire. (Those are the 4th from the left on the top and the fifth from the left on the bottom.)
Turn the ignition to on. You'll notice lots of flashing lights, but just pay attention to the ABS light. Normally, it should be rapidly and steadily flashing, twice per second. If it has stored a trouble code, it will instead be flashing a pattern that will coding a two-digit number. There may be more than one code being flashed out. It will just repeat the code over and over, so you have plenty of time to figure it out and write it (them) down.
NOW you can clear the codes. Just tap the brakes rapidly 8 or more times, about two taps per second. You don't have to jam on the brakes, just tap them enough to blink the brake lights. If you're successful, the ABS light should return to its normal fast blinking. Now remove the jumper wire, and finally turn off the key.
Now when you turn on the key, the ABS light should just do its normal light for three seconds and go off. If it comes back on, you still have a problem
ජය වේවා...
බුදු පොලයියේ මේ වැඩේනම් කරන්න එපෝ..... උබට මූට ඊසීයූ එකක් අරන් දෙන්න වෙයි


CCTV තියෙනවා අපේ ගෙදර..... අම්මලගේ ගෙදර නෑ..... කොටිය ආවෝ එකක් තියෙනවා.... කලින් හිටිය වෙන්ඩ මස්සිනා හයි කරපු..... ඒක වැඩ කරන්නෙත් නෑ.....


නාකි තොට මොන අක්කලාද.. ඇන්ටිලා ඇන්ටිලා 
කිව්වා කියලා හිතා ගනු.... මදෑ හෙට බාසෙක් ගෙනල්ලා ඒකේ අරුන් කාපු වයර් ටික හදාගන්න හිටියා...... මරාලයක් පාත් උනා.... අම්මලගේ ගෙදරට හොරෙක්/හොරු පැනලා......

